as well as setting and using Design Entry Carry Over Understand the - PowerPoint PPT Presentation

• Understand Managing Constraints with Design Line as well as setting and using Design Entry Carry Over • Understand the Benefits of using Button Mapping Loops to reduce Button Mapping definitions • Understand Fitting Extensions, and using Optimize Fitting Extensions • Learn to use the configuration and profiles for the Design to Fabrication Revit Environment

Constraints are used when routing piping to pick sizes of pipe, or round ductwork and can be used for sizing of ductwork and pipe.

Design Entry Carry Over is used for Design Line when Item Information is needed from one Item to the next or for an entire Service

Current Values are used when information needs to be applied to Items on a specific Service by default. As shown Cost Code “10 - 100” will be applied to ALL items on this Return Air service.

Button Mappings with Loops helps eliminate duplicate/repetitive Button Mappings while ensuring proper fill with Design Line

Fitting Extensions are applied at the Item Level, using Properties, then assigning the Min and Max Values for each. For example Elbow throats and Transitions can be set to stretch to a minimum and maximum value, preset in the item, which reduces the number of short joints in a run of ductwork.

• Copy and Paste Button Mappings into the Fabrication services • Save Service database • Reload the configuration in REVIT